1Directions for use000690678.01 Xenon SAWheelchair
105.0 Quick Release WheelsQuick-release axles on rear wheel The rear wheels are equipped with quick-release axles. The wheels can thus be installed o
11Wheel lock lever extensionThe longer lever helps to minimize the effort needed to set the wheel locks. The wheel lock lever extension is screwed to
12Footplate Various footboards are available on the Xenon SA. These can be flipped up to make it easier to transfer to/from the chair. They are descri
13Width Adjustment of the footrestsIf the footrest width needs to be adjusted, please undo the screw (1), set the desired width, by positioning 1, 2 o
14SeatingSeat slingUse the Velcro straps under the sling to tighten/loosen the seat sling.Adjusting the seat heightTo change the seat height, please r
15Rotate the axle bracket (Standard)Using the quick-release axles, take the wheels out of the axle plug / sleeve.Undo the screws (1) and remove the ax
16CastorsSetting the Castor, Castor adapter & Castor forkIf the wheelchair veers slightly to the right or left, or the castors flutter, it may be
17BackrestTo adjust the back angle, please undo the Allen screw (1) and remove it. Set the desired position and then refit the screw in this position
18Wheel alignmentAdjusting the wheel alignment NOTE: To achieve the very best movement, the rear wheels must be adjusted to their optimum position. Th
19Single Post Height-Adjustable ArmrestsATTENTION!Neither the sideguards nor the armrests are to be used for lifting or carrying the wheelchair.1. Fit
2IF YOU ARE VISUALLY IMPAIRED, THIS DOCUMENT CAN BE VIEWED IN PDF FORMAT AT WWW.SUNRISEMEDICAL.COM OR ALTERNATIVELY IS AVAILABLE ON REQUEST IN LARGE T
20Sideguard with clothes protectorThe clothes protector prevents clothes getting dirty from spray water, (Fig. 6.39). You can set the position in rela
21Crutch holderCrutch holder (Fig. 6.44)This device permits crutches to be transported directlyon the wheelchair. It has a Velcro loop to fastencrutch
22Stabilising barFolding stabilising barThis bar is used to stabilise the backrest. To be able to fold the wheelchair, the release lever must be pushe
23Lap strapWARNINGS!Before using the wheelchair make sure that the pelvic • restraint belt is fitted.The pelvic restraint belt must be checked on a da
24Lap strap (continued)When fastened check space between the lap belt and user. When correctly adjusted it should not be possible to insert more than
257.0 Daily ChecksCAUTION!As the user, you are the first person to notice any possible defects. We therefore recommend that before each use, you check
2610.0 Trouble shootingWheelchair pulls to one side• Check tyre pressure• Check to make sure wheel turns easily (bearings, axle)• Check the castor a
2712.0 NameplateThe nameplate is located on either the cross-tube assembly or the transverse frame tube, as well as on a label in the owner’s manual.
28Technical Specifications (continued)Maximum weight limit:Xenon SA up to a load of 125 kgSeat heights:The choice of frames, forks and castors as well
29Technical Specifications (continued)Castor ForkSeat heightfront / mmSeat height rear / mm76 mm (3")98 x 32420 420 - 370430 430 - 370440 440 - 3
3ForewordDear Customer,We are very happy that you have decided in favour of a high-quality product from SUNRISE MEDICAL.This owner's manual will
30Technical Specifications (continued)Castor ForkSeat heightfront / mmSeat height rear / mm127 mm (5")98 x 32440 430 - 370450 440 - 370460 450 -
31Technical Specifications (continued)Castor ForkSeat heightfront / mmSeat height rear / mm178 mm (7")123 x 45480 480 - 370490 490 - 370500 500 -
32Technical Specifications (continued)Centre of Gravity MatrixStandard clampPassive clampLightweight clamp
3314.0 Torque SettingsNOTE: If no specific torque information is given, the generic torque value for M6 screws is 7.0 Nm
34NOTES
35NOTESDealer signature and stamp
Sunrise Medical GmbH & Co.KGKahlbachring 2-469254 Malsch/HeidelbergGermanyTel.: +49 (0) 7253/980-0Fax: +49 (0) 7253/980-111www.sunrisemedical.comS
4Table of Contents3.1 Denitions of words used in this manualWord DefinitionDANGER!Advice to the user of Potential Risk of serious injury or death if
5General safety notes and driving restrictionsThe engineering and construction of this wheelchair has been designed to provide maximum safety. Interna
6securely mounted parts (e.g. not on the footrests or the sideguards).Danger!When using the lifting ramp make sure that the anti-tip tubes tted are p
72.0 WarrantyWarrantyTHIS DOES NOT AFFECT YOUR LEGAL RIGHTS IN ANY WAY.Warranty conditions1) Repair or replacement is carried out by the authorised Su
81. Push handles2. Back sling3. Sideguard4. Seat sling5. Footrest 6. Castors7. Footplate8. Fork 9. Quick-release axle10.
94.0 HandlingFolding up First remove the seat cushion from the wheelchair and flip up the (platform) footplate. Take hold of the sling or the seat tub
Commentaires sur ces manuels