Quickie Rumba Modular Spécifications Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
14 Quickie Rumba
Ref: P19093
WARNING!
4.20 Use on a slope:
Your wheelchair has been designed and tested to allow its
use on slopes or gradients of up to 10° (18%) on Rumba
and 8º (14%) on the Rumba modular.
Before attempting to climb or descend a slope or a
kerb, caution should be taken when using weight shift
options (e.g. powered recline) of the seat and/or your
body for a counter balance weight.
To improve stability lean forward when driving uphill,
with the seat and back in an upright position.
Alternatively sit in an upright position when travelling
in a forward, downhill direction or recline the seat
backwards. We strongly recommend that you return
back to an upright lowered position before attempting
to climb or descend a slope.
Failure to do this may cause the wheelchair to become
unstable.
If you are in any doubt about the capabilities of your
wheelchair on a slope then do not attempt to drive
up or down the slope/kerb; try to find an alternative
route.
WARNING!
4.21 Gradients: ascents:
When going uphill, keep the chair moving.
Steer by moving the joystick from side to side.
If you have stopped on a hill, you should start slowly.
On a RWD chair, if necessary lean forward to prevent
the tendency for the front wheels to lift.
WARNING!
4.22 Gradients: descents:
On descents, it is important not to let the wheelchair
accelerate beyond its normal level of ground speed.
It is safer to proceed slowly down steep descents
(below the speed of 5kph) and stop, if any anxiety
arises regarding directional control.
If the chair picks up speed, centre the control to slow
it or to stop all forward movement, then restart slowly
and do not allow the speed to increase.
WARNING!
4.23 Lap belt:
Before using your wheelchair ensure the Lap belt is worn
and correctly adjusted before use.
The lap belt is fitted to the wheelchair as shown in the
fitting instructions in section 5.7 & 5.8. It is important that
the belt is secured around the back of the wheelchair. The
straps can be fed between the armrest and backrest.
Adjust the belt position so that the buckles are in the
centre of the seat. See section 5.7 & 5.8.
Adjust the lap belt to suit the user’s needs as follows:
To increase the belt length:
Feed the belt through slide adjusters and male buckle to
provide more belt length, (Fig.4.18).
To reduce the belt length:
Feed the belt back through male buckle and slide
adjusters, (Fig.4.19).
Fig.4.18
Fig.4.19
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Commentaires sur ces manuels

Pas de commentaire