Quickie 2HP Guide de dépannage télécharger pdf (Page 14)

930302 Rev. E

IX. Chair Basics

A. TO MOUNT & REMOVE REAR WHEELS (OPTIONAL)

Do not use this chair UNLESS you are sure both quick-release axles are

locked. An unlocked axle may come off during use and cause a fall.

NOTE– Axle is not locked until:

a. The quick-release button pops out fully. (Fig. 1)

b. The ball bearings are fully visible on the

outside of the sleeve.

1. To Install Wheel (Figs. 1 & 2):

a. Depress quick-release button (1) fully. This will

release tension on ball bearings at other end.

b. Insert axle through hub of rear wheel.

c. Keep pressure on button (1) as you slide axle

(2) into axle sleeve (3).

d. Release button to lock axle in sleeve. Adjust

axle if it does not lock.

e. Repeat steps on other side.

2. To Remove Wheel:

a. Depress quick-release button (1) fully.

b. Remove wheel by sliding axle (2) out of axle

sleeve (3).

c. Repeat steps on other side.

1. Quick-Release Button

Figure 1

3. Axle Sleeve

2. Axle

Figure 2

VIII. Warnings: Components & Options

930302 Rev. E

5. Do not alter or substitute wheelchair frame parts, components or seating.

6. Sudden stops or impacts can structurally damage your chair. Chairs involved in

such incidents should be replaced.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of con-

trol may occur and cause severe injury to the rider or others.

P. TRAVEL WHEELS

• Do not exceed 250 lb total weight.

• Intermittent use only

• May decrease rearward stability.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Pas de commentaire

Quickie 2HP Guide de dépannage Page 14