Quickie 2HP Guide de dépannage télécharger pdf (Page 21)

IX. DEALER SERVICE AND ADJUSTMENT

ENGLI S H

128226 Rev. A

J. ARMREST RECEIVER ATTACHMENT

Mounting

1. Place the two receiver clamps (A) onto the top portion of the rear side frame tube. Align with the

preferred location of the single post height-adjustable armrest.

2. Pinch both clamp receivers together at the armpost receiver side and insert the 3 hex bolts (B) into

the armpost receiver.

3. Once inserted, Hold both clamp receivers against the top portion of the rear side frame tube and

tighten the hardware (B) .

Adjusting the Armrest Fit

1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 hex bolts (D) by using a 7/16"

wrench .

2. With the armrest assembly in the receiver (C), press firmly on the outside of the receiver.

3. Maintain pressure on the receiver and re-tighten two of the hex bolts (D).

4. Remove the armrest assembly and re-tighten the remaining two hex bolts (D).

5. The armrest will fit firmly in the receiver and lessen any noise that may result from vibration.

L. PADDED SWING-AWAY ARMRESTS

Swing-away armrests can be removed or can swing away to allow lateral transfers. They are height adjustable

(1" increments) by moving Quick Release pin (E) up or down in predrilled holes on armrest bracket.

Additional height can be achieved by removing bolts (F), flipping and rotating the hardware and Receiver

Bracket (G). Ensure bolts (F) are retightend.

Swing-away, removable armrests are installed by sliding armrest into receiver (G) on back frame.

383736

1 2 ... 16 17 18 19 20 21 22 23 24

Pas de commentaire

Quickie 2HP Guide de dépannage Page 21